Complete with control knob Viton® O-rings on PTEF shaft are protected with two precision Teflon® wipers (or as shown in the second picture O-ring is inside shaft) The plug has a machined-in integral PTFE tip O-ring to make the primary...

To be used with constant pressure retention kit (S69)

Plugs and barrels are ground to be interchangeable with 1:10 taper

With 10/18 joint, immersion length is measured from the bottom of 10/18 joint on thermometer to lower end of filling liquid bulb. Filling liquid is Kerosene based. Measuring range: -20°C to +250°C. Accuracy is ±2°C.

This replacement kit is complete with one PTFE plug (1:5 taper), one PTFE handle, one PTFE washer, one O-ring and PTFE nut.

Flanged type stopper with a hollow plug and sleeve extension that folds down over the neck of vessel, tubing, etc. The diaphragm can be punctured with a syringe needle, resealing after needle is withdrawn. Stoppers are made from natural...

PTFE-Hahnküken mit T-förmigen Bohrung

With 10/18 joint, immersion length is measured from the bottom of 10/18 joint on thermometer to lower end of filling liquid bulb. Filling liquid is Kerosene based. Measuring range: -20°C to +250°C. Accuracy is ±2°C.

With 10/18 joint immersion length is measured from the bottom of 10/18 joint on thermometer to lower end of filling liquid bulb Filling liquid is Kerosene. Measuring range: -20°C to +250°C. Accuracy is ±2°C.

With 10/18 joint, immersion length is measured from the bottom of 10/18 joint on thermometer to lower end of filling liquid bulb. Filling liquid is Kerosene based. Measuring range: -20°C to +110°C. Accuracy is ±2°C.

With 1:5 PTFE plug and a threaded pressure nut Stopcock barrels are polished to prevent PTFE plug from scratch

This replacement kit is complete with one PTFE plug (1:5 taper), one PTFE handle, one PTFE washer, one O-ring and PTFE nut.