Products from Synthware

A grease-free, two-piece sublimation apparatus consisting of an upper watercooled condenser and lower vessel to hold the material to be sublimed. The sublimate collects on the lower end of the condenser which has a flat bottom. Condenser...

Grease-free design. With 14/10 threaded joint and PTFE-lined septum for syringe access. For application in electrochemistry, spectroelectrochemical analysis.

For great solvent/chemical resistance, the two 0-4mm vacuum valves have PTFE covers over the two Viton® O-rings on the shaft and one integral PTFE O-rings on the tip, without exposing any material other than PTFE to any solvents. Syringe...

With joints for easy removal of condensate. Center tube hose connection is always 10mm for easy connection to manifold bank tubes which are also with 10mm hose connection.

Syringe port has 14/23 outer joint for a rubber septum and a 4mm PTFE Stopcock. Solvent is drained through 2mm T-bore PTFE stopcock. The drainage arm has a 14/23 inner joint.

Distilling head only. Condenser and flasks not supplied. Access port has threaded 14/10 joint to accept a PTFE-lined silicone septum with a compression cap (supplied). Threaded 14/10 joint also accept regular 14/23 glass or PTFE stopper...

With a fritted disc of coarse or medium porosity to support resin. Top of the vessel has GL thread and a PTFE lined screw cap. PTFE stopcock has a 2mm bore. (For porosity grade see table in appendix).

Upper sampling port has a 4mm PTFE stopcock with a 14/23 outer joint for use with septa. Lower drain is centered to allow total drainage of storage head.

Similar to S13 but with drip tip on the delivery port other than 14/23 inner joint. With 4mm straight bore stopcock in the upper portion for easy syringe needle access.

With 4mm double oblique, vacuum solid glass stopcocks precision ground with corresponding numbers on barrel and plug. Solid glass stopcocks have constant pressure retention devices. The smaller (17mm O.D.) front tube is for inert gases...

With 4mm double oblique, vacuum solid glass stopcocks precision ground with corresponding numbers on barrel and plug. Solid glass stopcocks have constant pressure retention devices. The smaller (17mm O.D.) front tube with hose...

General purpose manifold with PTFE stopcocks with 2mm or 4mm bore. Main tube is 22mm O.D. with serrated hose connection (10mm O.D.) at left side. Delivery ports have 10mm serrated hose connections with O.D. of 10mm. Distance between...